Hi Guys
due to me being unable to post in the non commercial vendor section you must read fitting instrutions here
PLEASE folllow below instructions as you all now there have been problems with fitting some other branded muffliers out there and my test muffliers melting the out side of the mufflier arch on the rear bar
*first remove factory muffliers (dur) keeping gaskets and bolts..... Ps: a bit of WD sprayed on the rubber mufflers hangers will help ALOT
*fit up new muffliers (BOTH) with the gaskets and bolts hand tight so the flangers are very close together *NO silicon reqired*
*NOW this is where it makes all the differance,[i]you must push up and out *45degs* and hold it there (with a bit of muscel) while tighting the bolts [/i]on the flanges on both sides
*you will notice the tips sit close to the inside of the mufflier arch this is not a problem as when they get hot the factory Y pipe will open out moving them to the center ((DRIVERS side first followed by the passanger) and once cooled they will move back .if you find its touching the inside loosen the bolts adjust (see above) and tighten again
*those of you runing a custom or branded cat back system wont have this problem due to the Y pipe not having this movment problem (unless you CUSTOM center and Y pipe where made off center)
*if you would like these muffliers to sit in the center a tad more (at your own risk) you can drill out the flange bolt holes on the muffler and the Y pipe to a larger size giving you more adjustment to where the tips sit
Regards
Michael