Silver Gen3

[SX74SI]

Bought the car stock over a month ago now, did a littl DIY, painted my badge red, system was in 2 days after purchasing the car
Cadence ZRS6000, 1500peak watts monoblock
Pioneer DEH-P3000IB single din headdeck
and Kenwood kfc something something 12 inch sub in kenwood box 1400peak

little over a week ago got a set of 18inch akuma n-06's
and today had it lowered 2inches, not as low was i wanted, but the offset is wrong, getting an engineer to check out if its safe to machine the offset down a little, maybe 5mm
and guards getting rolled 2morrow

only pic i have right now, will get some more later

[Fangin_RX]

Looks good, need a side on so we can see what it looks like

[Sentinel]

and today had it lowered 2inches, not as low was i wanted

What da?? Not low enough, shesus, Mano would be wrapped with that comment!! How much lower did you want it??

Nice mods!

Need more pics mate!!

Cheers

[SX74SI]

ohh well that pik was taken after the drive home with 3 ppl, its actually quite a bit higher than that... but i was hoping for that low with just me

yeah more pix will be up later, havent really had the time to take any

[Arith]

Nice ... errr ... part of the car! Looking forward to the whole car one day. But yeah, you're better off getting wheels with the right offset to start with rather than trying to machine it to the offset you need.

[SLY60L]

The lower the better i reckon, i like my cars slammed on the ground...

[GTSPECB STI]

welcome aboard and congrats on the new ride, as Arith said do not machine offset but rather get the right wheels. Dropping it that low with wrong offset is going to cause some serious mechanical issues with your suspension set up sooner rather than later. If you are going that low then you best invest in a whiteline roll centre kit pronto.

[jdm rsk]

looks low enough to me

would not like to be sitting in back for to long

[loweart]

So, that's what it means when Mano say's "drop that shit"

[RXWAG]

where did you take your car to get lowered? what springs did you use and cost?

[SX74SI]

now that the springs have set, ive decided to keep it this height LOL

I got the springs done at allsprings moorebank, got compressed ones, the ride isnt bad, alot better than i expected

yeah, ive considered selling the wheels and getting different ones

Last night, gen4, gen3, and my bro's gen2


pic on my driveway, looks little higher than it does on flat land