09 XT Forester

[TMP243]

Well, I think it’s been long enough mourning the loss of OzFoz and my therapist suggested starting a new build thread with Club Lib.
So here goes..

Please bear with me while I insert the relevant information per each mod. It will no doubt take some time (three hours a day on public transport should cover that). I also see 1000 pixel images are not very friendly for phone viewing..







After I had the heat exchanger powder coated (coating by Plazmaman)

[TMP243]

Initially I had a Silicone intake, but wasn’t impressed with the fitment as it is suited for the stock TD04L. So I embarked on a little mission to make my own. Being a novice with 3D CAD this relatively basic design took at least a few years off my life but I managed to get there in the end with the down side of onset grey hair.
I intentionally went with a flange mount to achieve the smoothest transition around the TGV.
Printing using on the multi jet fusion is horrifically not cost efficient, hence why these are not readily available.

[TMP243]

[TMP243]

[bigBADbenny]

Unfnknblvbl

Picatinny mod rails DR L

I’m still on the list for an inlet yeah?

[TMP243]

[TMP243]

[TMP243]

[TMP243]

[TMP243]

[TMP243]

The Baro Mod!
Featuring a precision cut acrylic cover (adhered with roofing silicon). It's not too uncommon these failing due to water ingress, so the cover seemed like a suitable solution

[subyroo]

Simply gobsmacked!

[nvmylh]

Jeeeeeezus

[Yowie]

I think one of your machined fittings is out of spec by half a thou.

[TMP243]

I think one of your machined fittings is out of spec by half a thou.

After spending two hours going over all my custom fittings with the micrometer.. I give up, nothing exceeded .01mm.