FOUND! Quad tip STI mufflers MY08 3.0rb wagon

by **Gadgit7** » Mon Aug 24, 2015 4:41 pm

hi folks.
Looking for set of quad tip STI mufflers to fit my 2007 3.0r spec b wagon.
Also a set of raptor headers would be nice but I know that's near impossible so will probably get those new

(Scratch the headers, just ordered some new ones

)
Cheers

by **McDoof** » Mon Aug 24, 2015 8:43 pm

http://forum.liberty.asn.au/viewtopic.php?f=68&t=30556#p412020
How bout these

by **Gadgit7** » Mon Aug 24, 2015 10:58 pm

Sold sadly or I'd have them

by **Gadgit7** » Thu Aug 27, 2015 6:19 am

Hi folks,
I found some woohoo. Raptor headers coming mid October and mid pipe and quad tip STI mufflers coming Saturday. Should make the old girl sing nicely

by **McDoof** » Thu Aug 27, 2015 7:01 am

Gadgit7 wrote:Hi folks,
I found some woohoo. Raptor headers coming mid October and mid pipe and quad tip STI mufflers coming Saturday. Should make the old girl sing nicely

Result!
What mid pipe have you gone with? I still need to do mine at some point.

by **Gadgit7** » Thu Aug 27, 2015 7:25 am

Yeah a good result. Mid pipe and mufflers $600 so pretty good I reckon. Mid pipe is a Liberty 2006 STi which I think is a bit bigger than standard so better flow but no droning hopefully. And with a Matt re tune should be a nice but subtle sound and some extra grunt. I,m hoping the mid pipe will just fit up to the raptor headers but I have a mate who is a wicked tig stainless welder

so he'll make it all work anyway.
It's off a sedan and mine is a wagon so might need some fettling but I,m hoping it won't be too much of a hassle to make it all fit.

by **McDoof** » Thu Aug 27, 2015 7:49 am

The midpipe is the same on the sedan and wagon. Only the tail pipes are different. If you have got wagon tail pipes you will need to have the exhaust pulled back a bit to get the tips under the valance.
Here are some pics of my Raptor installation. I had the whole front section fabricated, but kept the stock cats to keep the noise in check. It's worth doing because the stock front section is double walled, so the inner pipe is only 1.75". The header installation is not just a bolt on solution, you must cut the stock exhaust and weld in the provided flanges.
http://forum.liberty.asn.au/viewtopic.php?f=10&t=26449&start=60#p411380

by **Gadgit7** » Thu Aug 27, 2015 8:03 am

NICE! Thanks mate, good to get an idea of what I have to do. I have a sedan set going on my wagon so it should be ok I hope?
Like the ways yours sounds, mine will be quieter with the STI mufflers but should still bark a bit more than standard.