vented fenders...

[LIB3RTiGT]

...following on from the recent post by Arith (link below)

http://forum.liberty.asn.au/viewtopic.php?t=2970

i recently noticed these have popped up on japanparts.com for the early model gt libs from a company called burnout.



after seeing how good similar fenders look on a tb sti spec b i must admit im kinda tempted to try out these.

at the end of the day the question is, are they worth the trouble of ordering, importing and painting / fitting?

thoughts?

[Kevlar GT]

I like them.

[senator]

jim...... where a you???

mate check the mods section their is similar vent you can add to your exisitng fenders, just need to cut and fold them.

See Arith's car, good example.

[PHAT GT]

i have a set of these in my garage which iv been deciding weather to fit for the last 3 weeks now (still undecided)

at a tad under 880 a guard (yes thats each) i would'nt buy another set

[Arith]

I also saw these as well. But they are only for the A~C series (MY04-MY06) and they had 2 vents rather than 1. That's why I needed Phat to custom order mine.

check the mods section their is similar vent you can add to your exisitng fenders, just need to cut and fold them.

Where is this? If I had known that I wouldn't have gone through the trouble of mine!

At the end of the day it's a matter of why you're modifying your Lib to begin with. These do not add any power nor do they dramatically effect appearance. However the uniqueness factor is high. For me I just wanted to try something different (I'm sure others may have tried and if they have I haven't heard or seen them yet).

[LIBIDO]

i'll take them off ur hands phat!!! hahaha 2 for the price of 1 right!?!?! haha

[XRC15T]

i'll take them off ur hands phat!!! hahaha 2 for the price of 1 right!?!?! haha

GO SSSSSSSSSSSSSSSSSSSSSSSSSSSSUPASTAAAAAAAAAAAAAR!!!!!!

[tangcla]

Is it flared as well as vented?

If not flared, you can get a panelbeater to vent it, and bog with fibreglass + mesh. I've seen my panelbeater do it on bonnets and fenders before.