4GEN Liberty and Legacy 3.0 Exhaust headers

[Tradewind]

Next thing

Do I restock? People needing headers should let me know and I can build a case to stock them again

Over to the people .......

Yes please - I reckon that once more people have them installed and have shared the results you will see more demand.

I know a couple of UK guys are waiting to see the results of the ones shipped over there first...

The results from the first 25 sets before this shipment can be found here there and everywhere across this forum and even this thread. I wouldn't have bothered if the results weren't showing consistent promise.

Will wait for a bit until a small order list develops then go again

[chanham]

headers arrived today, they look mint!

[Tradewind]

headers arrived today, they look mint!

Great to hear you like them. Your delivery was IPEC, that correct?

[chanham]

headers arrived today, they look mint!

Great to hear you like them. Your delivery was IPEC, that correct?

yep 2 sets via ipec. im all the way in w.a. so that should be the last of the australian orders!

[Nick3.0R-B]

Still waiting on mine..also IPEC..long weekend must be the cause.

[Tradewind]

Still waiting on mine..also IPEC..long weekend must be the cause.

Nic, PM me (your full name) as soon as you read this and i will have pack and send check the delivery progress for you. Have you used your tracking number, there should be information related to that.

Once I know the full name behind the forum handle I will get it sorted for you.

[RX25SE]

Still waiting on mine..also IPEC..long weekend must be the cause.

Same.

Mine were unloaded at lunchtime yesterday, so I'm guessing today is the day.

[Tradewind]

Maybe thats how it is

It is Road Express - maybe today is the day

[nhimsta]

Received my set yesterday , look quality,
Tracking info works well.
Getting fitted today , I had to drive a Astra as a loan car ,so looking forward to getting back in mine lol .
Will try and post up a clip when done and some feedback .

[Pixjnr]

Hi Tradewind,

I missed out on this round, but i am keen for a set in the next round. Any idea when this would reach 'critical mass' and likely timing?

Great work and lov'n the forums for upgrades.

Cheers, simon

[Nick3.0R-B]

Does the exhaust shop weld flanges to the existing system so these bolt up?

[Tradewind]

Does the exhaust shop weld flanges to the existing system so these bolt up?

That is an absolutely correct assumption - YES

[Tradewind]

Hi Tradewind,

I missed out on this round, but i am keen for a set in the next round. Any idea when this would reach 'critical mass' and likely timing?

Great work and lov'n the forums for upgrades.

Cheers, simon

Simon

OK, stay involved here for info on next order status.

People are very much doing the right thing in registering their interest - I can make a critical mass decision much sooner

[(sic)]

Hi guys,
If everyone doesn't mind, can they please post up how much their exhaust shops are quoting/charging? I got a quote today for $800>$900 (depending on how hard the bolts are to get undone), which includes installing them, custom SS pipes to the single inlet, sensor bungs and 1x 100cell cat.
I probably could get it a bit cheaper if I get one of those magnaflow cats, but im sure it would be negligible.

[Nick3.0R-B]

That sounds excessive..