Member Profile - Bezzza

[shav]

Looks awesome. Thanks for the update

[Bezzza]

Looks awesome. Thanks for the update

Exhaust guy had his doubts about the "internet" system, but only took a couple hours to fit.
He was very impressed and said by far the easiest one he has fitted

Made a nice change from the usual 2 cuts and 180 rotating of piping he's used too haha :p

[shav]

Looks awesome. Thanks for the update

Exhaust guy had his doubts about the "internet" system, but only took a couple hours to fit.
He was very impressed and said by far the easiest one he has fitted

Made a nice change from the usual 2 cuts and 180 rotating of piping he's used too haha :p

This just confirms for me that the invidia dp is the way to go.

Just refresh my memory, what cat back system did u fit again?

[Bezzza]

I have a fujitsubo system from previous owner.
The below is the join to mid pipe with the flex welded it. Cut the mid pipe reducer out so it's now 3" all the way to Y-Pipe.

[shav]

Looks great. Is a flex pipe necessary or did u fit one to avoid cracked welds?

[Bezzza]

Precaution more than anything. May be my mind but has reduced nvh also from the system.

[Bezzza]

My fun for tonight


Should all compliment the dump pipe nicely.

Also did my front swaybar & links the last week. Has reduced roll even more and car turns in much sharper with a hint of oversteer (before was under with just rear).

[shav]

making love to your TMIC I see.

I have that same panel filter

[jslayz]

Progress !!
Tune coming no doubt...???

J

[bigBADbenny]

Lookin goood

[KiDo_Tuning]

Photo shows no rear O2 sensor installed? Did they fit it after the photo?

[Bezzza]

All on the car now. It really is MASSIVE compared to the stock intercooler
Had to trim the bonnet slightly to fit the BOV under. Apart from that little hiccup, all fits well

Photo shows no rear O2 sensor installed? Did they fit it after the photo?

There is the single O2 sensor just on the turbo side of the flex joint. In factory position. This is the only sensor which we had to remove/reinstall to the new dump pipe.
Should there be another Matt?

Will be doing some logging and runs tomorrow night after I flash the new tune. Hopefully all will be running smoothly

[KiDo_Tuning]

I have a fujitsubo system from previous owner.
The below is the join to mid pipe with the flex welded it. Cut the mid pipe reducer out so it's now 3" all the way to Y-Pipe.

Cool, so it went in where the bolt was in this pic?

[Bezzza]

Yep went in where the bolt is, shadow just hides the wiring in the pic.

[Bezzza]

So have flashed my new tune for the mods.
Small issue with boost cut which has been rectified.

Car has plenty of boogie now
Slight increase in induction noise from dump and filter, but nothing outrageous.
Exhaust sound is not as harsh as before the dump install, guessing this is due to the unrestricted flow now.

All in all very happy with the outcome and no doubt with a few more revisions back and forth with Matt, the fun will only increase!

Also after any advice on gauges/tools which would be a good idea to purchase to keep an eye on things.
Will currently just be using my Tactrix and learning view to do a fortnightly check.


EDIT:
My learning view after the tune for those interested.
I'm still reading up on the logging aspect of things so don't fully understand what the below means just yet. I am slowly getting there though :p