Er 55 code on dash cluster.

[Mat04]

After plugging everything back in on my car, I started the car and while it was ideling I had "er 55" show up on the cluster.

Does anyone know what error code 55 stands for?

[cliffo3rb]

Had it pop up before after working on the brakes.Learning view said it was vehicle speed sensor.

[Mat04]

How did you rectify the code?

[cliffo3rb]

How did you rectify the code?

Just cleared it on learning view.

[Mat04]

Has it occurred again once cleared.

[cliffo3rb]

Has it occurred again once cleared.

Nah all good.

[Kekotic]

http://www.justanswer.com/subaru/2vbw3- ... layed.html

It's actually Error SS, for speed sensor.

[Mat04]

Ok sweet thanks

[Mat04]

So as the box did t have fluid in it would that throw the error code?

[alessandro132]

So as the box did t have fluid in it would that throw the error code?

If it didn't go after you reset your ECU then there's a good chance one of your sensors has been damaged and will need to be replaced. This happened to me after a rushed wheel alignment once where it was damaged with a ratchet. I think it cost me $400 to fix (but this was at North Shore Subaru).

[Mat04]

1 sensor wasn't plugged in. Problem solved thanks guys.

[alessandro132]

Very good outcome

[Mat04]

For that problem yeah. Than run the engine for a bit longer once fluids are filled up and it's bellowing white smoke out the exhaust. Looks like it will be coming back out to get pulled down and check again.