hey guys so i thought i might share with you all, i wanted to change my grill but did not want a carbon looking one, so i thought my grill and DIY it so here is the result.
so what i did is as follows.
took off the grill
on the back there is 3 screws what hold the chrome wing in place.
went to my local hobby store and got a can of Tamiya TS-6 black spray paint. $12.00
sprayed it with a distance of 30cms away, this will give u a even coat
i then hung the wing in my bathroom with the heat lamps on heating the room up.
i did 2 coats in total, on the last coat left it in the bathroom under the lamps for about a hour, just to make sure it sets nice.
you can see in the pic these fins i took off
i then grabed a set of super sharp side cutter from my local Jaycar Store, http://www.jaycar.com.au/productView.asp?ID=TH1891
i then cut the fins that run from top to bottom, using the side cutters
i used a stanely knife and heated it up then carefully took the left over plastic pieces that where left from cutting.