Project Veloci

[MH3.0R]

Settle down you lot! I am the one who should be getting excited!

Well, we will see what the numbers are like in the 0-100 times first. Went a little backwards from the last image, but economy and shifting are both improved. The shifting was my main focus, the economy is an unexpected bonus. But I do be wanting my power back combined with the shifting will be an awesome daily.

[AB501UT!0N]

I had some time on my hands this arvo and started to play with the fog light surrounds.

They now look like this:









Might have to also try the centre bit.

Absolutely love the honeycomb grills they look awesome and that power is crazy thats like three times the power my car has

[Tradewind]

Settle down you lot! I am the one who should be getting excited!

Well, we will see what the numbers are like in the 0-100 times first. Went a little backwards from the last image, but economy and shifting are both improved. The shifting was my main focus, the economy is an unexpected bonus. But I do be wanting my power back combined with the shifting will be an awesome daily.

All very interesting.

[MH3.0R]

Started to play with the centre section of the grille and these are the rough in shots, to see if I like the concept:





Still needs a complete frame and I am working on that part. Also needs some blackout work behind the mesh for consistent look with the fog lights surrounds.

[Corsair]

Personal opinion...but one piece of mesh too many. I think you should leave the middle empty to highlight the rest.

[SegR]

I agree.

[MH3.0R]

Yes, all good feedback. I will not do anything permanent in case I decide I don't like it, then a snip or two and back to stock! The blackout work could be done with some matt black film that can be removed later.

[HoFF]

Not a fan sorry.

[Rome_BRZ]

Yeh get rid of the middle piece, have it how the post facelift spec B bar is, with just the grille and fog light inserts with honeycomb...

[bigBADbenny]

I say stick to the plan, with the blackout done properly, you may not even require a frame in the center (unless required to locate the mesh).

[MH3.0R]

Thanks all for the feedback. I'll try for a bit better finish, then make a d after that.

[MH3.0R]

I got a nice surprise in my email last night! My 1st E85 image!

Can't wait to burn off the tank of fuel I filled up with earlier this week so I can try it out.

Stay tuned (no pun intended) for the results, posting soon!

[libz05]

Yeh get rid of the middle piece, have it how the post facelift spec B bar is, with just the grille and fog light inserts with honeycomb...

exactly what i was going to say!

[libz05]

hey mark!
i sent you a PM regarding the foglight surrounds/inserts with honeycombe !

[libz05]

Thanks all for the feedback. I'll try for a bit better finish, then make a d after that.

are you able to take a pic of your front end so i can have a better look how the foglight inserts look with the honeycoombe???
really keen on doing it also ! just over the preface 3.0r-b foglight sections