My new liberty with mods :)

[Boostaddict]

My BOV reference line often pops off the plastic manifold end. I recommend starting here.
HTH.

+1 for this ^^^^ since the fmic mine has done this too

[<GB>]

I haven't test driven the car yet but I found the following things:

Intercooler pipe had separated where they join near the battery this happened because my car has had an issue in the past blowing boost hoses off and rev zone had welded nuts onto each side of the pipes and had them wired together tight to stop the pipes separating in the middle, both sides didn't have the wires I've put cable ties on and this will hold hopefully.
The others side intercooler pipe near the filter wasn't far from blowing off the clamp was nearly off!!!! I fixed this and cable tied the nuts too.


My radiator cap wasn't fully on it needed another 1/8th turn till it was closed correctly

The coolant over flow bottle was bone dry!!!


A gouge in my fuse box cover and on my inlet manifold that werent there before.


I'm going to put the car in the hoist and check it tomorrow and make sure everything else is ok

[bigBADbenny]

Got a spare fuse box cover... Or get the Phat coin box ver$$$ion

HDI clamp$$$?

[Kekotic]

Got a spare fuse box cover... Or get the Phat coin box ver$$$ion

I think he was talking about the one in the engine bay Ben.

[bigBADbenny]

There's one in the engine bay???

Good spot to leave tips for your mechanic, but...

[Kekotic]

There's one in the engine bay???

Good spot to leave tips for your mechanic, but...

Are you fucking serious Ben? Look at that big black box behind the battery

[<GB>]

Got a spare fuse box cover... Or get the Phat coin box ver$$$ion

HDI clamp$$$?

The one under the bonnet near the battery as keiren said.

My car has the best type I'd clamps available, what are the hdi clamps? The issue is the shit piping

[bigBADbenny]

Hdi clamps are affordable versions of aerospace quality wiggins clamps...
Have to weld on the fittings, but it's set and forget after that

[<GB>]

Hdi clamps are affordable versions of aerospace quality wiggins clamps...
Have to weld on the fittings, but it's set and forget after that

Got a link?

[bigBADbenny]

Website needs flash...
http://www.hybrid-power.com/
http://www.youtube.com/watch?v=uaFC5MXxSJM
http://www.google.com.au/search?hl=en&s ... Zh2XOOehBM
$40 - $80 each but u could probably get trade pricing...
Plus, they look sexy!

[<GB>]

They look pretty much like what I've got now

[bigBADbenny]

Great! Hdi clamps = no silicone joiners.

[<GB>]

Put the rig up on the hoist today to check it out and the only thing I can find wrong with it at this stage is hole in my rear part of my cam cover where it joins the head it's about the size of a 10 cent peice the bit that's missing is still attached by som foam padding stuff that' seals it to the head. Not impressed !!

[Boostaddict]

Top quality just for you!!! ^^^^^


(say in asian voice)

[<GB>]

so i have been driving the car around for a few weeks and its been running great but its started to idle rough again and slowly got worse, i ve found the problem can anyonw guess what this is?