Extractor Manufacturing

[west_minist]

They are Loboka cats and they are good. I had the engine light come on about 2 weeks after they were fitted, but Edward of XTR adjusted the rom to get rid of the light problem. Edward is really good, after he has finished the tune, he seems happy to make extra adjustments without asking for more money.

There are somethings you cannot charge for. That's gratitude!!!

[Tradewind]

I will also add that Edward (XRT) provided an updated tune for my local customers H6 vehicle, to give more range on the 02 sensor values. New tune arrived within 10 mins of being requested

[nickk__is]

Raptor headers installed. Here is a short clip of the exhaust. I'll make a better one tomorrow for everyone.

Raptor headers, 2 100cel high flow cats with 2 into 1 pipe connected to xforce centre and ypipe with TCP auto mufflers

[LovinDeath]

Raptor headers, 2 100cel high flow cats with 2 into 1 pipe connected to xforce centre and ypipe with TCP auto mufflers

Sounds good. I would like more info on the 2 to 1 pipe, where did you get it made?

[nickk__is]

Sounds good. I would like more info on the 2 to 1 pipe, where did you get it made?

I had Windsor exhaust make it up. Unfortunately I can't tell you what it cost for just the 2 into 1 pipe as I didn't get a quote on that single part of the exhaust job. However, for the installation of supplied headers, supply and instal of 2 high flow cats and the fabrication and figment I the 2 into 1 pipe the total cost of the job was $750. If I was to take a stab in the dark, I would assume that approximately $200 would be the cost of making up and fitting the 2 into 1 pipe.

Hope that helps

[Fluf]

So you've got the stock cans on the end then?

[3rspecb]

So you've got the stock cans on the end then?

Taken from

Raptor headers, 2 100cel high flow cats with 2 into 1 pipe connected to xforce centre and ypipe with TCP auto mufflers

[Tradewind]

Nik

Make a drive by video, giving it some beans - should sound wicked

[nickk__is]

Heres a drive by clip with the new exhaust setup

Incase I havent stated my setup enough times on the other threads , here it is again

Raptor performance headers, 2x 100 cel high flow cats, 3rd cat delete replaced with 2 into 1 pipe, xforce centre and y-pipe and TCP auto mufflers

[kiko.man]

Can't wait to pick up my headers tomorrow! I've got a question though, I've been told by a friend that upgrading the stock cats to 100cel is not required?

He said that the changes would be minimal even with the new headers but instead, I should replace the 3rd cat with a 2 into 1 pipe. Apparently that's where changes will be seen.

Can anybody confirm that because I've seen a few opinions on the forum but I don't want to blow $400 on cats if the changes are zero to none.

Ian

[kiks]

Your friend is wrong.

[Tradewind]

Heres a drive by clip with the new exhaust setup

Incase I havent stated my setup enough times on the other threads , here it is again

Raptor performance headers, 2x 100 cel high flow cats, 3rd cat delete replaced with 2 into 1 pipe, xforce centre and y-pipe and TCP auto mufflers

Well done, sounds great!!

[Fluf]

Your friend is wrong.

+1 what this guy said

[kiko.man]

Cool, thought I'd check

Also, Nicks liberty sounds awesome!

[Tradewind]

Maybe 200cpi cats are fine too, better gas cleaning (less issue with catalyst threshold CELs) and still flowing very freely for any NA 3.0