Project Veloci

[jaydece]

Good for you mark, that's 1 happy customer out of so many unhappy ones?

What can I say? As you know...I have a very negative / bad experience with HPF

I hope they look after you and your car in the present & future

All the best mate! I would like to experience your car and Gino's sometime....I do have a soft spot for supercharge cars

The auto box valve body mods were done by Kewish Automotive and I think the DBW tune was then touched up by HPF, but not really sure. Anyway, when I go back to Kewish in May, I will speak more about who did what.

When I get the shift points sorted, I will take you for a run, but I rarely let other drive my car so I can only ever blame myself if anything goes wrong. I would hate for you manual box boys to use D for drag, then when you get going, slip it into R for race...

I do not wish to be the driver...but merely the passenger holding onto his seat as you go through the gears........

I'll make a date? you and gino take me for a spin on dyno day?

[MH3.0R]

Ok, after all the domestics out of the way. I finally got to mounting the Sports Grille with the new plastic mesh on the car. Excuse to go out to the garage was to replace a faulty fog light bulb, and, well, while I was there, a few other chores had to be done....

I have not yet hacked the middle section out as I am still playing and not 100% decided yet. These shots are with no Subaru badge. Missus reckons it needs one and I sort of think it does too.









All comments welcome.

[Kekotic]

Looks good Mark but it needs a badge for sure. white badge might be a good look....

[3rspecb]

Looks good Mark but it needs a badge for sure. white badge might be a good look....

+ 1

[<GB>]

I'd go with th mrs lol women are always right

[cruisn]

Needs badge, and car needs black wheels.

Im stripping a mates car this morning who has those rims professionally painted in satin black and wants to get a set in the oem finish to sell the car with.

[3rspecb]

Needs badge, and car needs black wheels.
Im stripping a mates car this morning who has those rims professionally painted in satin black and wants to get a set in the oem finish to sell the car with.

that will look tasty, dot it...

[MH3.0R]

With this black n white theme going, I will be accused of being a Collingwood supporter!

Need to break up the transitions with some chrome according to the Mrs, and she ain't ever wrong!

[Kekotic]

Need to break up the transitions with some chrome according to the Mrs, and she ain't ever wrong!

She let you drive with those ugly chrome rims on for a year.....

[MH3.0R]

Dropped the car in to the transmission place this arvo. She is getting new heavier clutch packs, heavier bearings, higher quality seals, new hydrauilic pump and regulator, then tuning the valve body for shifting at 6000 rpm.

Will keep you posted as I hear more, but I do not expect the car back until next Monday, unless I get an early flight back from Sydney on Friday.

[bigBADbenny]

That grille looks sensational! Yea, bring on the black wheels...

What about "chrome over a gloss black" on 18" preface spec B's like I suggested to Mark? Mmmm classy!

[cruisn]

Chrome wheels?

Im sorry but your wife is wrong.

How long is the chain that she can see the car from the kitchen to make that assumption anyway?

[Kekotic]

Chrome wheels?

Im sorry but your wife is wrong.

How long is the chain that she can see the car from the kitchen to make that assumption anyway?

Marks drunk everyone!

[cruisn]

Chrome wheels?

Im sorry but your wife is wrong.

How long is the chain that she can see the car from the kitchen to make that assumption anyway?

Marks drunk everyone!

Hahahaha, yes, my post style changes a little with a few bevvies.

Id hardly call 6 stubbies drunk though.

[bigBADbenny]

Mark: did you 2 tone those wheels? I'd like to see that (on this car too)