T.Renshaw34 - Project Liberty - JDM SPEC B FRONT END!

[JKeep2.5i]

nice list you also left out rota

[t.renshaw34]

Lol. Thought everyone knew what gravels are already. Can't justify the extra on the enkie's for only a 1kg saving per wheel, when the gravels are already 10.9 kg each.

[augo]

What offset are the "Gravels"?

[t.renshaw34]

18x8.5" +44
Went Nitto NT05's over P Zero Rosso's.
Heard they where the better of the two.

[t.renshaw34]

Todays work...

DSC01261.jpg (189.46 KiB) Viewed 3950 times

DSC01259.jpg (160.35 KiB) Viewed 3950 times

DSC01264.jpg (175.44 KiB) Viewed 3950 times

DSC01266.jpg (154.86 KiB) Viewed 3950 times

DSC01267.jpg (169.51 KiB) Viewed 3950 times

DSC01270.jpg (166.91 KiB) Viewed 3950 times

[t.renshaw34]

DSC01271.jpg (112.39 KiB) Viewed 3945 times

DSC01272.jpg (206.46 KiB) Viewed 3945 times

DSC01298.jpg (106.66 KiB) Viewed 3945 times

Dynamatt pics will be up when I finish it. Takes a little longer than I had allowed for today.

[Dropz]

Need more camber, get wider control arms.

[t.renshaw34]

Haha 6/7 degrees on the front isn't enough already??? Feels crazy to drive through the hills. Didn't even notice the rear until today. Needs wider wheels and 245 tread.

[<GB>]

where is the dynamat going?

[Dropz]

everywhere but the engine bay by the sounds of it from his list the other day!

[HyRax]

-18x8.5" Gravels
-245/40/18 Nitto NT05

I'll be keen to see how you go with the 245 wide rubber. I know there's heaps of clearance on the inside for it, but on an 8.5" rim, it is going to rub the rear guard and stick out a bit on the front with the only rub risk being lowering.

I tested this just yesterday with a mate's 8.5" wide Gravels with 245/45/18 rubber (yes, granted it's a bit bigger than 245/40/18) and it makes me think that the realistic width limit without flaring the guards would have to be 235 so it can tuck in a little.

[t.renshaw34]

Looks like I might be getting my guards flared. Was considering the damd front fenders. They allow a 20mm extra clearance on the out side. I am already rolling the guards.

Ideas on how much it cost to get two guards flared?

[HyRax]

I got both my rears rolled for $60 each, which is a little more expensive than some places, but he was a mobile service - he came to me. He also does flaring, but I don't know what he charges, presumably only a little more than rolling.

Anyway, in your case it's beside the point - he's in Sydney, but there must be something similar down your way.

[kiks]

6-7 degrees?

Dude with 5.4 degrees on prodrive GR sti control arms, I was extending braking distances a dangerous amount. Back to 1.5 degrees and tyre temps are down, handling unchanged, tramlining reduced, and braking so much better. And thats with proper shocks and R comps. Not Bouncy Chit.

[kiks]

Alsoi you say it took a while...How long was spent detailing the inside of the guards? Jesus thats pristene! I need glasses