Haven't quite got all the niggling issues sorted yet such as camber (new coilovers aren't camber adjustable) and tyres, but during the wait for their arrival I had the time to grind back my guards and various bits and pieces to avoid any more scrubbing that I used to get on my old rims (which sat 1mm in compared to these).
Yeh the way I test fitted them was pretty ghetto, but I was in a rush and was far too excited to get it done properly lol. I'm sure there will be a few haters out there who think they're just not functional, waste, stupid etc etc but I personally like it.
Anyways without further adieu, introducing my new rims...
Enkei NT03+M
18x9.5 +40 in Silver.
Was a limited run by Enkei organised by Spun Performance (I think), as these normally don't come in this size with 5x100 PCD
A little bit of dish + concave never hurt
As you can see, fitment is quite tight
Need more camber
As you can probably see, fitment is tight, and there's a bit of poke, but I'm fairly confident I can get them to fit with 235/40/18's or 245's if I decide to put my ride height up a bit. I definitely need camber bolts/plates to get -2.5ish in the front for clearance, while the rear I'm fairly sure they'll clear with -1 or -1.5. I've run the above set up before with 18x9 +35's and had very minimal issues.
Let me know what you all think
Darren.
