Gen 3 ignition light

[talev788]

For some reason the light from my ignition is no longer working.
Does anyone know the correct way of removing the top half of the steering thingy so i can replace the bulb?
I can remove the bottom half no problem but then i'm sorta stuck

[sheppo9]

The shroud/s?
Undo the screws from underneath, take of the bottom section.
Drop the steering column all the way down and the top pops off - held on by a couple of ordinary clips.

[talev788]

thanks for ur reply mate,
i just figured it out this morning myself after tearing a few bunches of hair out lol
now im in another problem, replaced the globe but the other globe is now not working.. checked all the fuses they are fine
my only idea may be that i have another faulty globe? but i am unsure

[sheppo9]

What "other" globe?

[talev788]

What "other" globe?

the one i replaced the original with...

[Dropz]

Faulty wiring perhaps? Did the new globe even work for a second? If it at least flicked on then maybe there is a short and it is over powering the globe.

[talev788]

Faulty wiring perhaps? Did the new globe even work for a second? If it at least flicked on then maybe there is a short and it is over powering the globe.

nah it didnt even flicker

[Dropz]

Use a test light for power in the wires, also LEDs only work one way (must have positive and negative the right way around), whereas normal globes are bipolar.