by hectickmind » Sat Jan 20, 2018 3:22 pm
SIX: -you will need 4x 85cm pieces of speaker wire, some black tape, voltage meter, pliers, soldering ion if you can solder (i can't and refuse to)
use the diagram on previous post to join your 4 pieces of speaker wire to the now cut wires of the amp cable.
I tried pulling up the door trim and carpet to feed wires...DON"T!! feed the wires from your amp cable through the holes in the carpet under the passenger seat, up through the dash. you can get your hand in there and pull the carpet off the floor, it won't hurt the car. now match the wires up to the correct colors on the head unit. did you feed the wires separately and join them one at a time? same! it'd be inconvenient otherwise.
now! head-unit power. black cable is ground. it should have a black jumper attached to it. use the voltage meter to find the constant power on. than he acc on. i didn't use a diagram but i'm sure there is one
all done!! clip and screw it all back in. REMEMBER TO PLUG HAZARD JUMPER BACK IN
-any cuts, swearing or loss of patience from the install is not my issue. take your time, stereo installs are never straight forward unless you pay someone to do it for you
- Attachments
-
- DSC_5289.JPG (233.14 KiB) Viewed 6089 times
A poser uses phrases like 'cheaper to' 'better off' 'easier to' and 'why'
While a real enthusiast tells you exactly what you want to know and what you're in for.
Cuts, cash and swearing means you've modded your car right!