Thanks, it was definitely trial and error to begin with.
And yeah, my old setup was pretty drone-y, it's the only thing I like about the new system. But I'll definitely look into changing the inlet.
And on a different note, today I decided to finally clean up my headlights.
My basic process was 400 grit side to side, 800 up and down, 1200 diagonally one way, and then 2000 diagonally the other way, all wet sanded with soapy water.
After that I used the pads and polish from my rain-x kit, the sandpaper was just because they were really bad and needed quite a lot off. I used rust-oleum 2x ultracover clear to seal them.
I am terrible at taking before photos, but here is one done.
Then of course, it started to rain so I had to cover it up and put the other side on hold.
This afternoon once the weather improved I finished off the other one.
Way better than before, and hopefully the light output will also be better.