gen3v8 wrote:Ditto ditto
WSID
13.66@101mph 15lbs boost
I didnt know you were only running 15psi Dave.
Pulse must tune with a lot of timing for you to hit 210kw!
gen3v8 wrote:Ditto ditto
WSID
13.66@101mph 15lbs boost
peadya100 wrote:gen3v8 wrote:Ditto ditto
WSID
13.66@101mph 15lbs boost
I didnt know you were only running 15psi Dave.
Pulse must tune with a lot of timing for you to hit 210kw!
peadya100 wrote:Are you saying id be running more timing at 19psi than a car making the same power at 15psi Alexei?
KiDo_Tuning wrote:Alexei is hopefully joking. Less engine load needs more timing and 15psi is a lot less engine load
Forester XT on Geolanders and a VF52 + TMIC ran a 13.07 on 16psi, it runs less timing on its current 19psi tune.
KiDo_Tuning wrote:peadya100 wrote:Are you saying id be running more timing at 19psi than a car making the same power at 15psi Alexei?
Alexei is hopefully joking. Less engine load needs more timing and 15psi is a lot less engine load
Forester XT on Geolanders and a VF52 + TMIC ran a 13.07 on 16psi, it runs less timing on its current 19psi tune as it pushes more airflow into the cylinder
alexeiwoody wrote:KiDo_Tuning wrote:peadya100 wrote:Are you saying id be running more timing at 19psi than a car making the same power at 15psi Alexei?
Alexei is hopefully joking. Less engine load needs more timing and 15psi is a lot less engine load
Forester XT on Geolanders and a VF52 + TMIC ran a 13.07 on 16psi, it runs less timing on its current 19psi tune as it pushes more airflow into the cylinder
No, I'm saying the pulse dyno is a bit happy, and I THINK it's not actually making the same power as you. The difference in time slips seems to support this?
Matt you're forgetting (or simply don't know that) Adam is tuned specifically for P100 with 2-3 degrees more in there...
(Edit: Just re-read your comment Matt... trying to make yourself look better by giving out a lesson in tuning, like it was needed. This doesn't actually answer Adam's question - which was to do with timing adding power. I pointed out that Adam is already running the same timing (per load) if not more...and you chimed in that he's not running the same timing table. Well, yes. That would be quite the assumption to make?
Perhaps you should stick to making helpful contributions instead...?)
Users browsing this forum: No registered users and 0 guests