C1 map updated

[johnnyward]

looking for a link to download and burn to make my maps work i own a 2006 Spec b liberty

[Deep Heat]

http://kickass.to/toyota-denso-whereis- ... 82492.html

I think this is the one you want.

[johnnyward]

ok so i download the above torrent burnt it still not working any suggestions ??

[driscoll_86]

These are the instructions I followed for my 2006 (MY07) Lib;

1. Leave the downloaded .iso file compressed.

2. Use a DVD+R disc (which is more compatible with the DVD-ROM drive in your car. I used a “DL” (Dual Layer) DVD, in case there was insufficient space on a normal DVD, but the size, once written onto the DVD is 3.91Gb, so a normal, single layer DVD should also work (not tried). Note that not all DVD writers will write to a dual layer disc even if they will read one.

3. Disc burning software is critical. Windows Explorer or Roxio Easy Media Creator 10 did not work for me. I used ImgBurn which is a free download from the net.

4. Start ImgBurn.

5. Use “Write image file to disc.” option

6. Set source to the compressed "whereismapsver19.iso" file you downloaded from the torrent site.

7. Insert your blank DVD+R disc into your DVD drive. Note, the disc should not be formatted by you before you use it.

8. Set “Destination” to your DVD drive

9. “Test mode” unchecked. “Verify” checked

10. Click the “Change BookType” icon which is at the bottom right-hand corner of the ImgBurn screen and looks like an open book.

11. Click on the tab which corresponds with the manufacturer of your DVD drive.

12. Set “Change For:” to “ Drive (for DVD+R Media)” for a normal DVD, or “Drive (for DVD+R DL Media) if you are using a dual-layer disc.

13. Set “New Setting” to “DVD-ROM” (Note: Not all drives will let you change the BookType, if this box is greyed out you will probably need to use a different disk drive)

14. Click “OK”. A popup should appear saying “Success!”.

15. Under “Settings” set “Write Speed” to 1, or the slowest setting you can find.

16. Click the “Write” (picture) icon at the bottom of the left hand window.

17. Allow the program to cycle through the write and verification steps.

18. Eject the disc. Hope this works for you,

Peter.

[johnnyward]

Tried this even tried a different Burner program and Two different types of disks still no good

[ON555]

Put the original disc back in and then put the updated one in after. (original as in the one that came with the car).

[johnnyward]

And if I don't have an original ??