I have a 2006 liberty wagon 2.0R
The engine light is on with the cruise control light flashing.
I want to check the engine codes and was wondering if this is possible without an obd reader. I know on toyotas if you bridge a couple of the outlets it will flash the ecu in a sequence that will read out as the code. I can find the obd connector (I think 16 pin) under the dash on the right hand side however dont know what pins to bridge or if that will even work.
I have read on the legacy forums that they have a black wire with a plug and you just bridge those but I cant find these wires and I think it is different on my car. Surely this is possible.
Failing this if somebody near ferntree gully in victoria has an obd2 reader that I could drop by and use that would be good too.