Numberplate spacer/lift kit

[SegR]

[rooby]

I'm keen for front and back if you are taking new orders as well
I can get you car/plate specific measurements if you need.

[jp928]

I went a slightly different route here, but achieved the same result - see pic in introductions under my name, from 2008. I prefer to mount the plate on 4 holes, not just 2, so I make a 6mm marine ply plate to suit 4 holes in the plate, then put 2 c/sunk holes in it such that the plate centered vertically on the bar, and (as its a small plate) it doesnt hang into the air intake.
The rear plate std mount also irritated me (on wagon rear door), as every time I shut it the plate mount shakes and dings the panel. Same logic as front plate , except its on a 5mm alloy plate, with mounting holes low (plate high) so the load is centered vertically. Plate is secured with 4 screws again. Original attempt used 15mm wood plate, but with it high it made releaseing the tailgate difficult.
Will have to look at this method in alloy.....and screws top and bottom.
jp 08 gtb 6mt wagon

[AndrewCowley]

Mark are you still making these? I'd love set, front and rear. My car is a pre-facelift Gen IV.

[cruisn]

Yeh, Im getting to it.

Been busy at work lately.

[rooby]

Hey Mark,

Any chance you want to make another set of these?

[cruisn]

Not happening currently.

Too many other things on the go.

[rooby]

No worries

[SubMeister]

G'day Mark, please put me down for one once you crank up production again.

Cheers,
SubMeister

[SMI77]

+1 front/rear please.

[<GB>]

Where are u located?

[cruisn]

Werribee.

[<GB>]

Sweet I'm in east keilor, are you making Anymore?

[Lib 3.0LR]

Hi Mark might need one to, now with new bar.

[rooby]

Sorry for opening the flood gates Mark