liberty auto gear box stalling

Ask for help with doing something on your car here.

liberty auto gear box stalling

Postby awesomelibertyke » Sat Oct 01, 2011 12:52 am

Dear libertians,

could any one please suggest solutions to the following problem,

subaru liberty, MY92, 2.2L, auto trans

1. gearbox is stalling on sharp right turns, yup, so when I turn the steering right, irrespective of the gear engaged, the rpm meter goes way up to about 5-6000 rpm, car will usually disengage gear and gearbox will stall. it can then be corrected by returning steering wheel to the middle and the car will suddenly engage in gear, jerk then take off. similar but less frequent problem with left turns.

2. occasionally, on an incline, engine will strugle for fuel, but if u step on the accelerator pedal, it usually fixes the problem.

3. also, there is a delay with gear shifting, so, engine revs to 3-4000 rpm before changing gears. before the incident below used to changr at 2000rpm.

regular service done, recently the engine over heated, so had to replace water pump and radiator hoses and thermostat.

possible suggestions so far have been,

1. faulty gear box relay - dont know what or where that is?

2. fuel pump neads replacement

3. clutch plate replacement needed

4. blocked fuel lines

so yeah, any suggestions, hopefully with instructions would be helpful

thanks people
awesomelibertyke
 
Posts: 1
Joined: Fri Sep 30, 2011 11:08 pm

Re: liberty auto gear box stalling

Postby youngy69 » Sun Oct 09, 2011 7:50 pm

Oil level,condition?
Cheers
youngy69
 
Posts: 508
Joined: Sun Dec 30, 2007 1:57 pm
Location: Northmead,Sydney
Car: 93 RST,06XT FOZ,01 B4,80 SERIES CRUI
Real name: Eddie

Re: liberty auto gear box stalling

Postby jp928 » Thu Oct 13, 2011 9:32 am

Engine mounts gone, allowing it to move around, and pull on linkages..?
Stalling gearbox? You mean it loses drive? Engines stall, not gearboxes.
jp
jp928
 
Posts: 981
Joined: Fri Jan 04, 2008 9:27 am
Location: Melbourne
Car: 08 gtb 6mt wagon

Re: liberty auto gear box stalling

Postby 99rex » Thu Oct 20, 2011 3:55 pm

jp928 wrote:Engine mounts gone, allowing it to move around, and pull on linkages..?
Stalling gearbox? You mean it loses drive? Engines stall, not gearboxes.
jp


x2. id look at the engine mounts,maybe torque converter also ??
99rex
 
Posts: 89
Joined: Wed Oct 19, 2011 11:33 pm
Location: shire,sydney
Car: 99-00wrx
Real name: steve


Return to How do I?

Who is online

Users browsing this forum: No registered users and 2 guests