Guys, tried to connect again today, following the process as laid out in the 1st post from Hotwire. I did get some good initial signs as follows:
1. Blue light on the OBDII port connector on the VAG-COM cable
2. Comm3 configured at 4800 bps, 8 data bits, No parity, 1 stop bit, No Flow Control
3. When ignition turned to the ON position, heard fan cycling
4. ECUFlash started and Read ECU was selectable
Then things did not look so good:
4. NO indication of "ErHC" in the oddometer
5. Selected several likely vehicle groups from the popup list, 2004 through to 2006 with LGT and even the Non-USDM range. There are a total of 3 in the list that "may" work with my vehicle. I tried each of them.
Always the same ERROR in the ECUFlash log, Could not connect, Interface closed.
My vehicle is an Oct 2004 build ADM Liberty 3.0R 5AT. It is NA (no turbo) 6 cyl and has the Internal ROM number D2ZY101H. I did note that this ROM number does not appear in the configuration files for Liberty in ECUFlash.
Any clues as to why I cannot read my ECU ROM Image?