Hello Tim,
the pump is so quite there is no noise,but i would like to know flow pressure.
Regards
valadares wrote:Hello Tim,
the pump is so quite there is no noise,but i would like to know flow pressure.
Regards
KiDo_Tuning wrote:valadares wrote:Hello Tim,
the pump is so quite there is no noise,but i would like to know flow pressure.
Regards
At 44.1psi base fuel pressure it will flow 340lph(5.6 litres per minute) and with 15psi boost, would hold 270lph(4.5 litres per minute)
Assuming 550cc injectors, your need more than 3.3 litres per minute of fuel flow to have more fuel flow than what your injectors can flow
I also suggest having the Fuel Pump Duty Cycle transition table adjusted, as they run 33% on idle and cruise, then 67% under part throttle acceleration and finally 100% under full throttle. The larger pumps need more PWM Fuel Pump Duty on idle/cruise and then on part throttle too. I usually use 60%, 80% and 100%
valadares wrote:KiDo_Tuning wrote:valadares wrote:Hello Tim,
the pump is so quite there is no noise,but i would like to know flow pressure.
Regards
At 44.1psi base fuel pressure it will flow 340lph(5.6 litres per minute) and with 15psi boost, would hold 270lph(4.5 litres per minute)
Assuming 550cc injectors, your need more than 3.3 litres per minute of fuel flow to have more fuel flow than what your injectors can flow
I also suggest having the Fuel Pump Duty Cycle transition table adjusted, as they run 33% on idle and cruise, then 67% under part throttle acceleration and finally 100% under full throttle. The larger pumps need more PWM Fuel Pump Duty on idle/cruise and then on part throttle too. I usually use 60%, 80% and 100%
Matt,
did you read my email
Tradewind wrote:For those not wanting to read back through this thread so far, there have been a few recommendations
1. http://aeromotiveinc.com/products-page/ ... et-inline/ Proven to fit an 08 Outback H6
2. Sard 265l/ph fuel pump. (Proven to fit H6 Liberty, not sure if there is a part number/fitting kit needed for this pump)
3. http://www.deatschwerks.com/products/fu ... -fuel-pump (Said to fit, but not sure if actually proven to fit H6 car)
PUDZ RSC3.0RB wrote:Tim, everyone.
Can also confirm the below pump is also a direct oem replacement.
https://www.facebook.com/moddinganonymous/posts/699054906827894. Thanx Jackson.
Tradewind wrote:PUDZ RSC3.0RB wrote:Tim, everyone.
Can also confirm the below pump is also a direct oem replacement.
https://www.facebook.com/moddinganonymous/posts/699054906827894. Thanx Jackson.
Pudz
I don't know the answer on that one ........ sorry
Tradewind wrote:PUDZ RSC3.0RB wrote:Tim, everyone.
Can also confirm the below pump is also a direct oem replacement.
https://www.facebook.com/moddinganonymous/posts/699054906827894. Thanx Jackson.
Pudz
I don't know the answer on that one ........ sorry
Return to Raptor Superchargers
Users browsing this forum: No registered users and 3 guests