club.liberty.asn.au

Will a my06 Gt dash work in my my04 outback?

Mat04 wrote:Will a my06 Gt dash work in my my04 outback?

id say yes, the mounting points for everything should be the same.
but in saying that, you would probably have to transfer everything over to make it work
ie dash, center console, the center bit that goes over the trans tunnel, center storage compartment

Sorry I meant will the cluster work.

Mat04 wrote:Sorry I meant will the cluster work.

Oh your right Mat. Yes, it should work, would simply be just a plug and play

That's what I like to hear. I got a great deal on one today

Mat04 wrote:That's what I like to hear. I got a great deal on one today

Was that the one on eBay?

Yup. I sent the bloke a message on Tuesday asking if he had a cash price thinking $150 for it would be reasonable but he didnt reply till I won it for $53. Than to top off my eBay day I bought a gt bonnet for my wife's liberty with all the trimmings for $300

Mat04 wrote:Yup. I sent the bloke a message on Tuesday asking if he had a cash price thinking $150 for it would be reasonable but he didnt reply till I won it for $53. Than to top off my eBay day I bought a gt bonnet for my wife's liberty with all the trimmings for $300

Nice work, I was watching the cluster just out of curiosity. I guess his loss is your gain

Good work on the Bonnet too

That's what I was thinking.

Out of curiosity I sent casuals wreckers a message about the Sti they have there and he wanted $450 for the cluster so $50 is good

Mat04 wrote:Out of curiosity I sent casuals wreckers a message about the Sti they have there and he wanted $450 for the cluster so $50 is good

casula wreckers are way over priced.
they quoted me an outback bonnet for $1200, SunSpares quoted me $500 and SSS Automotive quoted George (Lib 3.0l) $500

Fair enough. I got quoted $1000 for a gt bonnet

How do you go about gettin the cluster out in these bad boys? I assume a MY04 Fozzy would be similar to my dash/cluster? Do you need to take the whole woodgrain finish off that goes all the way down into the gear stick/boot, etc? Need to replace a blown globe Sighh.

The cluster has 3 screws holding it in. 1 in the center and the top an 2 underneath next to steering coloum covers. You have to remove the 2 lower panels to get to these though.

Fitted cluster for all of 5 minutes. It's not plug and play the immobilized is part of the cluster so I need to get it programmed to suit my key. My $50 for the cluster is looking more like $300 to get it to work.