Page 1 of 1
Jack and Stand Points

Posted:
Sat Sep 04, 2010 11:08 am
by sebmacc
Hi everyone,
Just wanted to ask where the are the best (right) points to jack up and support the front of a MY07 Liberty? I'll be using a trolley jack to get the front off the ground and axle stands to support while I do the work. Any advice will be appreciated.
Thanks,
Seb
Re: Jack and Stand Points

Posted:
Sat Sep 04, 2010 11:27 am
by Kekotic
I wanted to ask this the other day actually.
I ended up putting my jack stands next to the regular jack spot for the car as I could only jack up the car from the sides with that as I don't have a trolley jack.
I wanted to put the stands on the axle but I wasn't sure where a good spot would be as it was all angled.
Re: Jack and Stand Points

Posted:
Sat Sep 04, 2010 12:09 pm
by Tank
I haven't used it yet but there should be a plate on the cross member behind the sump (or the plastic cover thing under there). Make sure you are well clear of the sump though before lifting. For the stands the normal jack points on the side are fine. I would avoid putting the stands anywhere on the axles, they will move and i assume the diff and cv joints wont like it either.
From legacygt.com, its off a gen3 outback but should give an indication.

Re: Jack and Stand Points

Posted:
Sat Sep 04, 2010 6:32 pm
by teK--
Be careful with the side seams if you put them onto jacks, they are very easy to damage if you rock the car or drop the car down quickly. Rear diff is fine to use as a jacking point.
Re: Jack and Stand Points

Posted:
Sun Sep 05, 2010 3:17 pm
by sebmacc
Thanks guys, appreciate the help
Re: Jack and Stand Points

Posted:
Sun Sep 05, 2010 6:15 pm
by jdm rsk
Stands I always put them on the lower control rear mounting point. I don't think using the jack points us a good idea athe body won't sit flat on top of the jack.
Re: Jack and Stand Points

Posted:
Thu Aug 06, 2015 9:03 pm
by ysKn
I'm gonna resurrect this thread with a question.
Anybody know if this is a suitable section to place jack stands and jack up the car?
I just tried it before and it
seemed fine.

Re: Jack and Stand Points

Posted:
Fri Aug 07, 2015 5:33 pm
by fedaykin
Owning an R32 Skyline, I'm quite paranoid about where to place jacks/stands, so I wouldn't put one there. Use the subframe mount points or something.
Re: Jack and Stand Points

Posted:
Fri Aug 07, 2015 5:39 pm
by norbs
ysKn wrote:I'm gonna resurrect this thread with a question.
Anybody know if this is a suitable section to place jack stands and jack up the car?
I just tried it before and it
seemed fine.

Perfectly fine.
Re: Jack and Stand Points

Posted:
Fri Aug 07, 2015 11:38 pm
by Brunsy3.0
Is this not the chassis rail?
Re: Jack and Stand Points

Posted:
Sat Aug 08, 2015 8:59 pm
by ysKn
fedaykin wrote:Use the subframe mount points or something.
Where is that?