club.liberty.asn.au

Good evening gents, just a quick question. I've been searching the internet for info on how to remove my rear seats in order to run some cables but have been unsuccessful thus far. Just wondering if anyone could give me a few tips before I tackle my new project this weekend? I had a quick look tonight and noticed two small "push in" style clips on either side of the bottom part of the seat but wasn't able to move it and didn't want to force the seat out incase I'd missed a step.

Cheers guys

Push the plastic clips in and pull up quite firmly, the seat cushion just pops up and out, there are 2 clips in total.

Once that is off it's all self explanatory you just undo a few bolts (4 I think) which hold the seat back on. Then the whole seat back slides up and off.

Put a bit of muscle into it

daniel come over to brighton and i will help you

pull it upwards with a bit of force...it is easy and as tek said 4 bolt 2 on each end and 2 in the middle

Thanks Guys, I thought it went something along those lines but was just a little worried that I'd break something if I "put some muscle into it" haha. Can't wait for Saturday to come now, I shall have myself a bit of fun and post my work on completion. Oh and shane, thanks for the offer but I'll give it a go and see what happens. If I run into problems then it's a date . Btw I'm looking to be a bit more active around here, so I'll probably keep an eye out for any meets around our area and try and put faces to names