Page 1 of 1
Getting a wire inside the car
Posted:
Sun Feb 21, 2010 9:46 amby CappZ
How would I go about getting a wire from the engine bay into the car?
I took my glove box out and the cabin filter is in the way so I couldn't see what I was doing and I couldn't get the wire through..
Anyone tried? Whats the best way?
Ps. I promise this isn't for the HID reverse lights lol
Re: Getting a wire inside the car
Posted:
Sun Feb 21, 2010 10:07 amby hamish_023
shouldn't their be those rubber holes that you run through into your cabin?? just run a stick in their and get someone to see where the other side of hole is???
Re: Getting a wire inside the car
Posted:
Sun Feb 21, 2010 10:10 amby CappZ
Yehh thats what I mean, I cut a little hole into it and tried to push the wire through but no luck.
Re: Getting a wire inside the car
Posted:
Sun Feb 21, 2010 10:14 amby teK--
Re: Getting a wire inside the car
Posted:
Sun Feb 21, 2010 10:38 amby CappZ
Hmm pictures help, but does the rubber seal get back in easily if i pull it out..?
Re: Getting a wire inside the car
Posted:
Sun Feb 21, 2010 1:47 pmby teK--
Yep.
Re: Getting a wire inside the car
Posted:
Mon Feb 22, 2010 10:38 pmby CappZ
And I should be able to reach around the cabin filter and pull the wire?
Re: Getting a wire inside the car
Posted:
Mon Feb 22, 2010 11:03 pmby teK--
it actually comes out a lot lower than that, it's deceiving
follow the cable coming out of the ecu it will come out from where that cable penetrates the firewall.
Re: Getting a wire inside the car
Posted:
Sat Aug 14, 2010 9:11 pmby joeyE
If you push in the bottom of the main wiring loom grommet/plug in to the cabin from the engine bay (on the right hand side below the intake air filter) and feed a wire through the bottom of it, the wire should come out in the right hand corner of the passenger side footwell, no need to take out the glovebox.