Getting a wire inside the car

[CappZ]

How would I go about getting a wire from the engine bay into the car?
I took my glove box out and the cabin filter is in the way so I couldn't see what I was doing and I couldn't get the wire through..
Anyone tried? Whats the best way?

Ps. I promise this isn't for the HID reverse lights lol

[hamish_023]

shouldn't their be those rubber holes that you run through into your cabin?? just run a stick in their and get someone to see where the other side of hole is???

[CappZ]

Yehh thats what I mean, I cut a little hole into it and tried to push the wire through but no luck.

[teK--]

viewtopic.php?f=6&t=1459

[CappZ]

Hmm pictures help, but does the rubber seal get back in easily if i pull it out..?

[teK--]

Yep.

[CappZ]

And I should be able to reach around the cabin filter and pull the wire?

[teK--]

it actually comes out a lot lower than that, it's deceiving

follow the cable coming out of the ecu it will come out from where that cable penetrates the firewall.

[joeyE]

If you push in the bottom of the main wiring loom grommet/plug in to the cabin from the engine bay (on the right hand side below the intake air filter) and feed a wire through the bottom of it, the wire should come out in the right hand corner of the passenger side footwell, no need to take out the glovebox.