club.liberty.asn.au

Hi All,

Installing the guages into the wifes liberty this coming weekend.

and I was wondering if anyone had some screen caps or a guide on how to get the wiring up into the cubby area for gauge installation?

Much Appreciated.

Matt

this link will give you a tip on how to actually get the Cobby out, then getting the wiring up there is fairly straight forward, there is plenty of space behind there & up the side.
as far as getting into the engine bay there is a small grommet on the left side of the drivers side of the cabin, that is sort of behind the air con unit, above the transmission tunnel...or from the engine bay its a little off centre towards the right side of the car, i think its near the clutch master cylinder

thanks for the info - most helpful