club.liberty.asn.au

hey guy's
i have bought an electronic boost gauge and i need to run cables from the dash to the engine bay, i need some feed back on how to get them in or wat is the best way to get threw the firewall any feed back would be great.
cheers steve.

i need to know that also

where are you planning to mount the gauge?

i bought the cubby pod from chris and have already mounted the gear as a trial, but need to run these cables. as the cables are being run i will be trimming up the cubby pod in the same fabric that is in the actual cubby to give it a more factory look

there should be some other cable or wires going through the firewll just squeeze it through

got it threw exactly like you said where other cables go threw, it was a bit of a shit fight thou, now all i need to do is connect them, but i have to find out which cable comes of that bright button so wen i turn the lights on its have its brightness and then wen i press it its at full brightness like the rest, as well as the brightness dial.