I bought a set of leather seats to fit into my 2004 2.5i wagon.
The leather seats came out of a 3.0R wagon
The leather ones are on electric rails but I only noticed when buying them.
When i went to install there's an extra black 2 pin connector for the seat motors.
On the drivers side, there's a wire taped up which connects to this input.
However the passenger side doesn't have this wire. Instead it has this cream coloured 4 pin connector which i'm not sure what it's for.
Looking for anyone who's done this swap before who can guide me to getting power to my passenger seat
(Currently cant put the rear bolt fully in cause the seat's position blocks it)
Cheers