by Gavin_M » Tue Nov 03, 2015 6:33 pm
Sooooo it turns out my notes are shit haha. Sorry dude. I've had a look at the car, pretty difficult to see without removing the airbox or the battery but I can tell you this much;
JDM HID loom uses a 6 pin connector with all 6 pins used. AUDM loom uses a similar 6 pin connector with only 5 pins used. The pins for both types of connector are the same and pretty straight forward to pop out of the plug, if you look into the front of the plug, there are little tabs that you can pop up with a small flat screwdriver, pins can then be pulled out.
I've taken the JDM connector off the the new HID lights and swapped it for the connector from the AUDM lights being removed. 5 of the pins from the JDM headlight loom are placed into the same numerical positions in the AUDM connector. I've soldered (poorly) two of the wires together on the headlight side and where they go into one of the pins, unfortunately I can't see which pin they're actually going into because the airbox/coolant overflow bottle are in the way. Wires joined together are a red and a yellow.
If you can get a wiring diagram for AUDM,JDM it'll help. Hope I've been of some help to you man.