Gen 4 bumper removal
Posted:
Tue Oct 13, 2015 1:22 pmby 2008Liberty
Hey fellow lib owners!!
Looking at removing my headlights this weekend to get Leo to install some Halos for me...
I have heard you need to remove the front bumper in order to get them out? Is the correct? And if so has anyone got a quick run down on how to remove it?
Any help would be greatly appreciated!!
Regards
Scott
Re: Gen 4 bumper removal
Posted:
Tue Oct 13, 2015 4:39 pmby BillyCorgi
Words from the Factory Service Manual.....
11.Headlight Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the air intake duct. (When removing the
headlight RH).
3) Remove the front bumper. <Ref. to EI-30, REMOVAL,
Front Bumper.>
4) Disconnect harness connectors.
5) Remove the 7 bolts, disengage 1 clip, then detach
the headlight assembly.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Seems the instruction is to remove the front bumper.
Re: Gen 4 bumper removal
Posted:
Tue Oct 13, 2015 5:01 pmby 2008Liberty
BillyCorgi wrote:Words from the Factory Service Manual.....
11.Headlight Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the air intake duct. (When removing the
headlight RH).
3) Remove the front bumper. <Ref. to EI-30, REMOVAL,
Front Bumper.>
4) Disconnect harness connectors.
5) Remove the 7 bolts, disengage 1 clip, then detach
the headlight assembly.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Seems the instruction is to remove the front bumper.
Do you have the information from the factory manual on how to remove bumper?