Page 1 of 1

Fix drivers locking mechanism

PostPosted: Tue Sep 15, 2015 8:02 pm
by Adam24
Hello my drivers door will not lock or unlock useing the central locking remote. I have to use the key, the other three doors are all good. I have heard its a common problem. How can i fix it. Or what part do i need. Thanks :D

2005 subaru liberty wagon 2.5L

Re: Fix drivers locking mechanism

PostPosted: Tue Sep 15, 2015 8:17 pm
by HighTech RedNeck
There is a how to on the forum but if like me its time for a new actuator, i bought mine from www.partsouq.com for less then half of buying it from a stealership

Re: Fix drivers locking mechanism

PostPosted: Tue Sep 15, 2015 8:20 pm
by HyRax
Sounds like the actuator might be duff. Does the door actually make any noise at all when you try to lock/unlock it?

I reckon a wrecker will be the best bet for a replacement. Find someone who will sell you a damaged door on the cheap and then simply rip and replace. If you're not confident to do it yourself, just get any mechanic to do it for you.

Re: Fix drivers locking mechanism

PostPosted: Tue Sep 15, 2015 8:45 pm
by Adam24
Thankyou. The door doesn't make any sound at all when i push the button. I am also thinking its the actuator.

Re: Fix drivers locking mechanism

PostPosted: Tue Sep 15, 2015 9:05 pm
by BillyCorgi
From those who have responded on the thread regarding the central locking actuators, the drivers door is considered by far the WORST, MOST DIFFICULT door to do.
Good Luck!

viewtopic.php?f=12&t=10479&p=409511&hilit=actuator#p409511

Re: Fix drivers locking mechanism

PostPosted: Wed Sep 16, 2015 12:08 pm
by HighTech RedNeck
Pff I had mine done in 30min

Re: Fix drivers locking mechanism

PostPosted: Wed Sep 16, 2015 1:22 pm
by BillyCorgi
Great, everyone will be contacting you now for your advice!
Cheers!

Re: Fix drivers locking mechanism

PostPosted: Thu Sep 17, 2015 1:14 am
by michaelat
Hey,
I've had the same problem previously with an older pulsar on the front passenger side.

What I did was removed it and filled it up with lubricant (not literally filled it, but all the moving parts). That gave me another week while I could order another one. Had to do it again a week later, was definitely a weak actuator. I would suggest lubricating it while you wait for the new one to arrive.

Also, you'll figure out how to get it in and out, so if you're overly enthusiastic to get the new one in (like I would be), you can do it faster.

Good luck.