club.liberty.asn.au

I was after some assistance in installing an A/F ratio sensor on my 04 Liberty GT.

Havent had a chance to work on this car myself, but very keen to learn.

Some assistance would be much appreciated =)

Cheers

The af sensor is on the top of the dump pipe, just behind the turbo. Disconnect the connector and using a 22mm spanner or an o2 sensor socket undo the sensor. Fit the new sensor and clear the ecu memory.

Dropz wrote:The af sensor is on the top of the dump pipe, just behind the turbo. Disconnect the connector and using a 22mm spanner or an o2 sensor socket undo the sensor. Fit the new sensor and clear the ecu memory.

thanks for that.

is it within easy reach from the engine bay?

Yep. Its a 5 min job.

Perfect. Didnt take long to do at all.
Only thing is after the install and reset, its a bit rough when I come to a stop.... feels shakey .. where as it didnt before. Any suggestions?

Did you do it up tight? May be exhaust leak. Or faulty sensor?

Did you reset the ECU?