club.liberty.asn.au

Hi all,
I installed a Sard 265 fuel pump and want to install the Tomei reg. Looking in the engine bay, the standard fuel reg has the vacuum hose, one to tank and two to the motor. The Tomei only has a vac. plus two - in and out.
Can anyone let me know what to do to install this?
Experienced comments or link to info is much appreciated.
regards

Rob

The 04 Gt has what could be confused as two return lines on the regulator - will take some pics tomorrow and throw them up to show which one it should be going to

Mick

Champion!

Completely forgot to do this today in sunlight sorry

Will try tomorrow

Photo would be a really great help, thank you for the offer.
regards
Rob

Found diagram attached all sorted now. Joined red lines and installed reg. in blue line in place of the existing regs.

Digging up and old thread.

According to that pic, there seems to be 2 lines red and 2 blue lines. From what I can tell most regs only have a single in and a single return. Does anyone have a diagram of how to connect the GT to a regulator. Was thinking of getting a turbosmart 1200 FPR.

following

Yes, so here is what I think the factory setup is configured as. But how to connect a 2-port regulator???? Anyone.

The (A) part is actually a fuel pressure dampner. Leave it in place and put FPR on the blue line The vacuum line then goes to the new FPR

Purdy3.0RB can post up pics of how we did his hopefully

Ahh that makes more sense. Pic would be nice