Page 1 of 2

Gen IV low beam adjust

PostPosted: Mon Aug 06, 2007 12:10 am
by yumcha
anyone found out how to adjust the low beam on the GEN IVs?
doesnt say in the book

PostPosted: Mon Aug 06, 2007 1:21 am
by SkoobyGT
Adjust as in what?

Just get HID's :lol:

If you mean to angle the light down, Im fairly sure there are grey coloured bolts that you turn either way to go up and down, and another for side to side etc.

or?...... :wink:

PostPosted: Mon Aug 06, 2007 3:36 pm
by EJ25
there are 2 bolts on each light to adjust the vertical and horizontal.. i read somewhere about this.. the lights suck really badly for me too,, so im thinking about just getting HIDs..

PostPosted: Mon Aug 06, 2007 4:34 pm
by Mano™
me 3... :D 8) :lol:

PostPosted: Tue Aug 07, 2007 1:57 pm
by yumcha
i do have HIDs
thats why i need to adjust them
they are automatically aimed
lower after installing the HID

PostPosted: Tue Aug 07, 2007 6:59 pm
by WeeGraeme
Is there any modification required to fit HID lights, or are they a straight swap?

PostPosted: Tue Aug 07, 2007 7:02 pm
by XRC15T
Make sure you get lower K, i made the mistake of getting 6k....

PostPosted: Wed Aug 08, 2007 4:49 am
by SkoobyGT
Franky what do you mean mistake?

My 6000k's are fine. Yes they are bright, but I have not had anyone flash me yet.

They seem good in the wet too, with no loss of visibility.

Do people think different brand globes have slightly different outputs?

PostPosted: Wed Aug 08, 2007 10:36 am
by XRC15T
I found mine to be a bit too dim, they are ok around the city, but when you get out to the sticks or around some twistys, it could be a bit better.

PostPosted: Wed Aug 08, 2007 1:23 pm
by fish_boy79
lol my passenger side bulb is 4300k and driver side bulb is 6000k. 6000k looks better, but the visibility of 4300k is far superior.... especially in the sticks.

PostPosted: Wed Aug 08, 2007 4:52 pm
by EJ25
fish_boy79 wrote:lol my passenger side bulb is 4300k and driver side bulb is 6000k. 6000k looks better, but the visibility of 4300k is far superior.... especially in the sticks.

both hids?

PostPosted: Wed Aug 08, 2007 5:11 pm
by fish_boy79
EJ25D wrote:
fish_boy79 wrote:lol my passenger side bulb is 4300k and driver side bulb is 6000k. 6000k looks better, but the visibility of 4300k is far superior.... especially in the sticks.

both hids?


yup both HIDs. passenger side is JDM HID headlight, driver side is aftermarket HID kit.

PostPosted: Thu Aug 09, 2007 10:16 am
by IDOLYZ
i have the same problem as you yumcha. I need to adjust mine higher, as they are set really low when i put the HIDs in.

PostPosted: Thu Aug 09, 2007 11:05 am
by yumcha
WeeGraeme wrote:Is there any modification required to fit HID lights, or are they a straight swap?


very simple install

pretty much plug n play except you need
to drill a small hole to feed the cables
through the cap behind the H/L

shouldnt take longer than 30 mins for a clean install

PostPosted: Thu Aug 09, 2007 11:10 am
by yumcha
fish_boy79 wrote:lol my passenger side bulb is 4300k and driver side bulb is 6000k. 6000k looks better, but the visibility of 4300k is far superior.... especially in the sticks.


agreed

the factory 4300K in my mum's euro shits all over my 6000K
as far as lighting goes, but the colour of the 6000K is damn nice