by Surge » Thu May 04, 2017 8:51 pm
So I have attached the modified map.
This is as safe as I could make it, changes are:
* Initial WGDC set to 0, to run only wastegate pressure.
* Boost Control Disable is increased to 0.8 / 0.9.
* Primary Open Loop Fueling - everything below 11.2 set at 11.2.
* Failsafe Fueling is slightly richer in the high load area.
* The switch to the Failsafe table set to happen at 0.8 IAM.
* Base timing is lower in the WOT areas by about 4 degrees.
* Knock Correction Advance Max has been divided by 4.
* Initial IAM is 1.0. So no need to wait for IAM to go to 1.0 after a reflash.
After flashing, drive around staying out of boost if possible. Keep an eye on learningview after a test drive.
- Attachments
-
- Safemap.pdf
- (1 MiB) Downloaded 260 times