Page 1 of 1

EcuFlash v1.44 sending key / interface close

PostPosted: Wed Mar 09, 2016 1:02 pm
by ilament
Hey all,

I've been trying to read/write a new tune to my 04 GT (A2DW010Y) with no success. My EcuFlash log is below. This issue has occurred on 3 laptops using 2 different openport 2.0 cables. I've discussed this with another local member who has experienced a similar issue and we now believe it could either be my ecu or version 1.44 of EcuFlash causing the problem.

FYI both connectors are plugged in, fans are cycling with key to ACC & battery is tested at 12.7v.

I'm going to go to chiptorque tomorrow to get them to look at the ecu to search for any problems on that side, but I'd be really glad if anyone knows of issues/workarounds with v1.44 of the software if that's the issue.

Thanks!

[10:19:34.102] J2534 API Version: 04.04
[10:19:34.117] J2534 DLL Version: 1.01.4500 Jun 26 2015 15:08:08
[10:19:34.117] Device Firmware Version: 1.15.4474
[10:19:34.133] Device Serial Number: TAwmSUQU
[10:19:34.383] VIN read not supported
[10:19:34.539] interface close
[10:19:34.680] J2534 API Version: 04.04
[10:19:34.696] J2534 DLL Version: 1.01.4500 Jun 26 2015 15:08:08
[10:19:34.696] Device Firmware Version: 1.15.4474
[10:19:34.711] Device Serial Number: TAwmSUQU
[10:19:34.914] SSM2 init
[10:19:35.071] SSM2 ECU ID is 4F54507016
[10:19:35.164] Requesting Seed...
[10:19:35.227] Sending Key...
[10:19:35.289] interface close
[10:19:35.399] interface close

Re: EcuFlash v1.44 sending key / interface close

PostPosted: Wed Mar 09, 2016 3:53 pm
by andy_mac
Probably not your problem, but what vehicle type are you using in ECUFlash?

Re: EcuFlash v1.44 sending key / interface close

PostPosted: Thu Mar 10, 2016 8:28 am
by ilament
Just had a diagnostic from chiptorque.. ecu was locked even though I was told it wasnt. Winning!