club.liberty.asn.au

I am having trouble getting anything to show up when opening my ROM copied from the ECU.

I have just purchased a tactrix and installed the latest ecuflash and drivers.

I successfully copied my ROM file from the ecu however I open it and it only shows basic info only in the metadata column. I need to see fault codes at the bottom but nothing is there? Any directions on setting up ECU flash software?

Load the rom in romraider

Romraider seems to be down at the moment.. I think I may have set up with the wrong definition file for my ROM. Just figuring out how to go in and change it now. I can see it, just can't do anything with it. Very annoying

Iirc those softwares are very dependent on correct install, drivers and eg Java versions.
I have linked a pic of my last working setup in the Tune FAQ link in my sig, just to give you an idea...

I ended up reloading the tune from Matt and he turned off what i needed. I ran LV to check codes and none where showing up. Engine light stayed on.
I got in the car half an hour later to go somewhere and the check engine light was gone! So all good. However i still could not read my rom file using ECUFlash..