ECU Flash set up.

[AJ RS]

I am having trouble getting anything to show up when opening my ROM copied from the ECU.

I have just purchased a tactrix and installed the latest ecuflash and drivers.

I successfully copied my ROM file from the ecu however I open it and it only shows basic info only in the metadata column. I need to see fault codes at the bottom but nothing is there? Any directions on setting up ECU flash software?

[HardwareBoB]

Load the rom in romraider

[AJ RS]

Romraider seems to be down at the moment.. I think I may have set up with the wrong definition file for my ROM. Just figuring out how to go in and change it now. I can see it, just can't do anything with it. Very annoying

[bigBADbenny]

Iirc those softwares are very dependent on correct install, drivers and eg Java versions.
I have linked a pic of my last working setup in the Tune FAQ link in my sig, just to give you an idea...

[AJ RS]

I ended up reloading the tune from Matt and he turned off what i needed. I ran LV to check codes and none where showing up. Engine light stayed on.
I got in the car half an hour later to go somewhere and the check engine light was gone! So all good. However i still could not read my rom file using ECUFlash..