Page 1 of 1
Gen v gt auto dump pipe fitting?
Posted:
Thu Aug 20, 2015 2:31 pmby joseph.78
Looking into putting a invidia dump pupe on my car the dump pipe is 3 inch and the stock piping after that is 2 1/2 inch. Curious what people have done to correct this i am assuming putting some sort of cone to reduse the size near the flange?
Also is the invidia a good product?
Re: Gen v gt auto dump pipe fitting?
Posted:
Thu Aug 20, 2015 4:40 pmby kiwigene
Gen V or do you mean Gen IV? (What year?)
You can just bolt it up straight to the existing mid-pipe even though the sizes don't match.
It's not ideal, but it will still be an improvement over the stock dump pipe.
This is what I have, as I haven't decided on mid-pipe/y-pipe and muffler combination yet.
Re: Gen v gt auto dump pipe fitting?
Posted:
Thu Aug 20, 2015 5:04 pmby shav
Re: Gen v gt auto dump pipe fitting?
Posted:
Thu Aug 20, 2015 5:19 pmby joseph.78
I did mean gen 5.
As i am not planning to change the mid section i would like it to fit properly.
Also am considering avo any opinions?
They do have an adaption plate to go between the 2 different pipe sizes.
Avo is 195 cell the invidia is 100 cell.
Re: Gen v gt auto dump pipe fitting?
Posted:
Fri Aug 21, 2015 9:17 amby ferret89
Grimmspeed have an adapter that smooths the transition from 3" downpipe to stock cat-back.