club.liberty.asn.au

Can anyone recommend an exhaust shop in inner or western melbourne. Need to replace my CAT (in downpipe) and a few other little tid bits.

On the topic of CATs anyone have any recommendations? Looking at a 100 CEL with best flow.

Hey Norb, xforce cats seem to be a popular choice.

Were u after Stainless or mild steel work btw?

Thanks. I'll check out the XFORCE ones.

Not sure about stainless or mild. Either I guess.

norbs wrote:Thanks. I'll check out the XFORCE ones.

Not sure about stainless or mild. Either I guess.

Make sure they're the long taper cats.

Thanks Bruce. I think I'm going to get the TCP system (center, y-pipe, mufflers) minus the dump and mate it to mine. I have an AVO dump but the cat is cactus.

I've also been looking for a good place to get an xforce exhaust installed in Melbourne, except I'm in the south eastern suburbs. Anyone have any recommendations?

circlethesky wrote:I've also been looking for a good place to get an xforce exhaust installed in Melbourne, except I'm in the south eastern suburbs. Anyone have any recommendations?

Rowville Exhausts

bass_straitener wrote:

circlethesky wrote:I've also been looking for a good place to get an xforce exhaust installed in Melbourne, except I'm in the south eastern suburbs. Anyone have any recommendations?

Rowville Exhausts

Thanks, saw on their website they do xforce exhausts so if I can get them to order it and put it on themselves that would save me some effort. Bit further out than my area (narre warren/Berwick) but I will call them tomorrow to see if it's worth it.
Cheers

Hey mate did you have any luck with rowville exhaust? I'm looking at getting something made up and they're nearby. Cheers

MY02B4 wrote:Hey mate did you have any luck with rowville exhaust? I'm looking at getting something made up and they're nearby. Cheers

I still haven't made the decision on whether to get stainless or mild steel! It's a tough one...