Xforce +08 WRX dump pipe fit MY07-09 GT.b?

[jaydece]

3/ Remove the angle bracket on the dump as its not used

Mine was used. See pic here: http://i543.photobucket.com/albums/gg44 ... CI0815.jpg

Well going by experience with my car and looking at most setups available that angle bracket doesn't exist...

- phat dump
- AVO
- Ultrex
- Perrin
- TCP: http://forum.liberty.asn.au/viewtopic.php?f=43&t=8203&start=15
- Etc Etc...

[dutch7]

Hey Dutch,

My suggestions with your setup is this:

1/ Flex joint ( dont get a cheap one, chris @ best mufflers sells xforce ones )
2/ Bung for the O2
3/ Remove the angle bracket on the dump as its not used
4/ Cat? 100 cel / 200 cell ( should of got it off chris @ best mufflers as well )

good luck

Appreciate the info Justin. I assume the the flex joint is needed to weld the cat in the dump, as in one of your last pic? are there pros/cons for doing it this way instead of just having flanges welded to the cat and bolting it to the dump & mid?
I might end up going with the 100cel metallic cat from Best Mufflers, and grab a bung for the O2 aswell, can't beat their prices

Cheers,
Jamie