club.liberty.asn.au

This is to the wise men out there is club liberty......

Will these fit my veeehiicccclllee!! 07 TB STI.

http://pages.ebay.com/link/?nav=item.vi ... ID=EBAY-AU

no.
theyre for a wrx sti

Yeh i get that they are for an sti wrx.

But they look so damn close to what our mufflers look like. Im just woundering if , with a little bit of fecking around, that they would line up pretty darn close.!!!

I doubt it. They look shorter than the liberty mufflers. Nothing a welder and some handywork can't fix though...

prob be heappss loud...if thats what your going for..

Boostaddict wrote:Yeh i get that they are for an sti wrx.

But they look so damn close to what our mufflers look like. Im just woundering if , with a little bit of fecking around, that they would line up pretty darn close.!!!

hangers would defs need changing
and the curvy pipe after the hotdog would need bending or modifying to make it line up with the liberty y pipe flange. don't know if they do this, or just weld in a new section

not worth it imo

bates91 wrote:

Boostaddict wrote:Yeh i get that they are for an sti wrx.

But they look so damn close to what our mufflers look like. Im just woundering if , with a little bit of fecking around, that they would line up pretty darn close.!!!

hangers would defs need changing
and the curvy pipe after the hotdog would need bending or modifying to make it line up with the liberty y pipe flange. don't know if they do this, or just weld in a new section

not worth it imo

straight pipe that shit

There is a forum member who could give you a correct answer to this question. I am not at "liberty" to say whom.

bosc0 wrote:There is a forum member who could give you a correct answer to this question. I am not at "liberty" to say whom.

hahahha

bosc0 wrote:There is a forum member who could give you a correct answer to this question. I am not at "liberty" to say whom.

Beans......... Spill em!!!

I did email the seller. Might ask for dimensions too!!

Those would be freakishly loud! Just do a hogzorst instead.

Haven't found anyone to do it for less than $150 and then a little adjustment may be required
Plus, if you look underneath, the welds wont look exactly OEM. Pics/thread soon, promise!

Beans spilt!

They definitely could be modified to fit.
It would be so damn loud you would get a defect.

But maybe not on the stock mid lol