Hi Guys,
Is there any sealant that needs to go on the gasket between the manafold and the block of the engine when re-installing the genuine manafold? 2.0R.
Australian Liberty Owners Club
exhaust manafold
2 posts
• Page 1 of 1
exhaust manafold
by sti_stig » Sat Nov 12, 2011 5:27 pm
-
sti_stig - Posts: 238
- Joined: Tue Mar 29, 2011 9:12 pm
- Location: Sydney, New South Wales
- Car: 08' Subaru Liberty 3.0R Spec.B
- Real name: Mick
Re: exhaust manafold
by kiks » Mon Nov 14, 2011 6:17 pm
Just use the old gaskets and do em up to serena williams AHH! (not a venus williams ARRRGH, which will strip it) They re seal fairly well (never replaced in 330,000km and at least 15 times it's been undone and done up.).
Whats more important is to make sure the surfaces are clean etc. flat file on the manifold flanges to level them out etc as they always warp a little.
Whats more important is to make sure the surfaces are clean etc. flat file on the manifold flanges to level them out etc as they always warp a little.
- kiks
- Posts: 944
- Joined: Sun Feb 06, 2011 9:13 pm
- Location: Brisbane
- Car: 1UZTurbo HQ ute, Gen3 1GZ 5L V12 lib
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests