club.liberty.asn.au

Good to hear

bigBADbenny wrote:Still happening! I'm onto a local plastics CNC mill so the first ones may be delrin

Acetal is ok to machine, but you won't keep tolerances all that tight, you'd be better off doing it out of PETP, much better for tighter tolerances.

I'm assuming most people want these in metal, if people wanted plastic I could help get them pretty cheaply

Awesome! It's more for prototyping, I'm sure there's a local low volume aluminium CNC machining service

Sweet, good to see it's still rolling! Still very keen.

Same here

Me too!

lets get it rolling benny! i may be in too

Im just really interested in what these will look like

Brunsy3.0 wrote:Im just really interested in what these will look like

P7 of this thread has an initial design, for those that haven't seen it. But the holy grail will be the McIntosh knob design, which quite a few are very interested in.

tom_kauf wrote:

Brunsy3.0 wrote:Im just really interested in what these will look like

P7 of this thread has an initial design, for those that haven't seen it. But the holy grail will be the McIntosh knob design, which quite a few are very interested in.

Like of the headunit? that would be ideal, matching stuff <3

Yes, the headunit. Not so interesting for those that don't have the McIntosh system, buy a very cool looking dial either way I think.

tom_kauf wrote:Yes, the headunit. Not so interesting for those that don't have the McIntosh system, buy a very cool looking dial either way I think.

would look on point regardless

bigBADbenny wrote:Still happening! I'm onto a local plastics CNC mill so the first ones may be delrin

*pokes*

champ wrote:

bigBADbenny wrote:Still happening! I'm onto a local plastics CNC mill so the first ones may be delrin

*pokes*

poke poke

I'm interested to see some prototypes