Well everyone is slow on the clip posting so lets get it started with this one
https://youtu.be/Efwis47AeT4
Tewaka wrote:The clip I did with my Ultrex Mufflers, was shot in my garage with the door open, I used my Galaxy Note 5 phone to do the recordings.
ULTREX wrote:Well everyone is slow on the clip posting so lets get it started with this one
https://youtu.be/Efwis47AeT4
stocko wrote:Just bought a set of these and installed on my 05 gt. They sound awesome and look amazing was actually surprised at how bassy they are. My only grumble would be the left hand muffler sits slightly further out and down but that could be a number of things and hardly noticeable except to my ocd trained eyes. Top job guys super happy
ULTREX wrote:stocko wrote:Just bought a set of these and installed on my 05 gt. They sound awesome and look amazing was actually surprised at how bassy they are. My only grumble would be the left hand muffler sits slightly further out and down but that could be a number of things and hardly noticeable except to my ocd trained eyes. Top job guys super happy
Hi and thanks for the feedback.
We spent a lot of time getting the tips correct....lots of sample being made and tested and changed.
One thing we did find is that most liberties exhaust tips we came across are not equal to begin with - it was actually very difficult to find ones with equal tips to use as the development cars.( not sure if this applies in your case or not.) When we were developing these - we had to reject the first 3 liberty test cars as the mufflers sat differently and protruded further on one side than the other. Its not something anyone notices with the original mufflers as no one looks closely - but they do look closely after the nice new shiny mufflers are installed.
Based on our experience with the cars we were coming across in development, its not unusual for the Liberty system to twist/move slightly at the y pipe which will impact on how any mufflers will sit - including ours.
But the tips can be tweaked to get them sitting equal height if required if you have already loosened and rotated it on the flange ?
cheers
Rob
jiggabite wrote:Do you have an expected date the sedan mufflers will be back in stock?
Users browsing this forum: No registered users and 2 guests